Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2019Q70 3.7 LUXE, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASCRUISE CONTROL SYSTEMBASIC INSPECTIONICC SENSOR ALIGNMENTWORK PROCEDURE (PREPARATION)
2019 Infiniti Q70 3.7 Luxe, AWD
Work Procedure (Preparation)
2019 Infiniti Q70 3.7 Luxe, AWDSECTION Work Procedure (Preparation)
- ADVANCE PREPARATION FOR RADAR ALIGNMENT
- Adjust all tire pressure to the specified value.
- Empty the vehicle. (Remove any luggage from the passenger compartment, luggage room, etc.)
- Shift the selector lever to "P" position, and release the parking brake.
- Fully fill the fuel tank, and then check that the coolant and oils are filled up to correct level.
- Clean the ICC sensor area
of the front bumper grille.
GO TO 2.
- RADAR ALIGNMENT OPERATION AREA
Position the vehicle in a place that is level and where
W
: 3, 000 mm (118.11 in)
L
: 2, 000 mm (78.74 in)
H
: 2, 000 mm (78.74 in)
NOTE:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.