SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2019Q70 3.7 LUXE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASREAR VIEW MONITOR SYSTEM (DTC/CIRCUIT DIAGNOSIS)DTC/CIRCUIT DIAGNOSISPOWER SUPPLY AND GROUND CIRCUITDIAGNOSIS PROCEDURE
2019 Infiniti Q70 3.7 Luxe, AWD

Diagnosis Procedure

2019 Infiniti Q70 3.7 Luxe, AWDSECTION Diagnosis Procedure
  1. CHECK FUSE 
    1. Turn ignition switch OFF.
    2. Check that the following fuse is not blown (open).

      Power source

      Fuse No.

      Capacity

      Battery

      #34

      15 A

      Ignition switch ON

      #3

      10 A

    Is the fuse blown (open)?

    YES

    Replace fuse after repairing the applicable circuit.

    NO

    GO TO 2.

  2. CHECK DISPLAY CONTROL UNIT BATTERY POWER SUPPLY 

    Check the voltage between display control unit harness connector and ground.

    (+)

    (-)

    Reference value

    Display control unit

    Connector

    Terminal

    M80

    24

    Ground

    Battery voltage

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Perform trouble diagnosis for battery power supply circuit.

  3. CHECK DISPLAY CONTROL UNIT ACCESSORY POWER SUPPLY 
    1. Turn ignition switch ON.
    2. Check the voltage between display control unit harness connector and ground.

      (+)

      (-)

      Reference value

      Display control unit

      Connector

      Terminal

      M80

      23

      Ground

      Battery voltage

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    Perform trouble diagnosis for accessory power supply circuit.

  4. CHECK DISPLAY CONTROL UNIT IGNITION POWER SUPPLY 

    Check the voltage between display control unit harness connector and ground.

    (+)

    (-)

    Reference value

    Display control unit

    Connector

    Terminal

    M80

    20

    Ground

    Battery voltage

    Is the inspection result normal?

    YES

    GO TO 5.

    NO

    Perform trouble diagnosis of ignition power supply circuit.

  5. CHECK GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect display control unit connector.
    3. Check the continuity between display control unit harness connector and ground.

      (+)

      (-)

      Continuity

      Display control unit

      Connector

      Terminal

      M80

      12

      Ground

      Existed

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Repair or replace harness or connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.