SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2019Q70 3.7 LUXE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEDRIVER ASSISTANCE SYSTEMSYSTEM DESCRIPTIONHANDLING PRECAUTIONPRECAUTIONS FOR BLIND SPOT WARNING/BLIND SPOT INTERVENTIONBLIND SPOT INTERVENTION
2019 Infiniti Q70 3.7 Luxe, AWD

Blind Spot Intervention

2019 Infiniti Q70 3.7 Luxe, AWDSECTION Blind Spot Intervention
  • Do not use the Blind Spot Intervention system under the following conditions because the system may not function properly.
    • During bad weather (for example. rain, fog, snow, wind, etc.)
    • When driving on slippery roads, such as on ice or snow, etc.
    • When driving on winding or uneven roads.
    • When there is a lane closure due to road repairs.
    • When driving in a makeshift or temporary lane.
    • When driving on roads where the lane width is too narrow.
    • When driving with a tire that is not within normal tire conditions (for example, tire wear, low tire pressure, installation of spare tire, tire chains, non-standard wheels).
    • When the vehicle is equipped with non-original steering parts, brake parts or suspension parts.
  • The camera may not detect lane markers in the following situations and the Blind Spot Intervention system may not operate properly.
    • On roads where there are multiple parallel lane markers; lane markers that are faded or not painted clearly; yellow painted lane markers; nonstandard lane markers; lane markers covered with water, dirt, snow, etc.
    • On roads where discontinued lane markers are still detectable.
    • On roads where there are sharp curves.
    • On roads where there are sharply contrasting objects, such as shadows, snow, water, wheel ruts, seams or lines remaining after road repairs.
    • On roads where the traveling lane merges or separates.
    • When the vehicle is traveling direction does not align with the lane markers.
    • When traveling close to the vehicle in front of driver, which obstructs the lane camera unit detection range.
    • When rain, snow or dirt adheres to the windshield in front of a lane camera unit.
    • When the headlights are not bright due to dirt on the lens or if aiming is not adjusted properly.
    • When strong light enters a lane camera unit. (for example, light directly shines on the front of the vehicle at sunrise or sunset.)
    • When a sudden change in brightness occurs. (for example, when the vehicle enters or exits a tunnel or under a bridge.)
  • The Blind Spot Intervention system will not operate if own vehicle is on a lane marker when another vehicle enters the detection zone. In this case only the BSW system operates.
  • Blind Spot Intervention assist will not operate or will stop operating and only a warning chime will sound under the following conditions.
    • When the brake pedal is depressed.
    • When the vehicle is accelerated during Blind Spot Intervention operation.
    • When steering quickly.
    • When the ICC, DCA, predictive forward collision warning or forward emergency braking warnings sound.
    • When the hazard warning flashers are operated.
    • When driving on a curve at a high speed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.