2017 Infiniti Q60 Base, AWDFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. DIRECT ADAPTIVE STEERING INITIALIZE

    1. Set the steering wheel to the straight-ahead position.
    2. Connect battery terminal.
    3. Start the engine.
      CAUTION:

      Never drive the vehicle.

    4. Turn the steering wheel from full left stop to full right stop.
    5. Confirm the condition of turning the steering wheel is normal.

    WORK END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.