Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Infiniti Q60 Base, AWDFACTORY OEM SERVICE PROCEDURE
Steering Control System (Direct Adaptive Steering) (Basic Inspection And DTCS)
- DTC Index
- Basic Inspection
- Diagnosis And Repair Work Flow
- Additional Service When Removing 12V Battery Negative Terminal
- Additional Service When Replacing Or Removing DAST Parts
- Additional Service When Replacing Control Module
- DAST Calibration (Mode 1)
- DAST Calibration (Mode 2)
- Configuration (Steering Force Control Module)
- Configuration (Steering Angle Main Control Module)
- Configuration (Steering Angle Sub Control Module)
- DTC / Circuit Diagnosis
- DTC C13A0-00: Control Module
- DTC C13A1-00: Control Module
- DTC C13A2-00: Control Module
- DTC C13A3-00: Control Module
- DTC C13A4-00: Control Module
- DTC C13A5-00: Control Module
- DTC C13A6-00: Control Module
- DTC C13A7-00: Control Module
- DTC C13A8-00: Back Up Circuit
- DTC C13A9-00: Back Up Circuit
- DTC C13AA-00: Control Module
- DTC C13AB-00: Control Module
- DTC C13AC-00: Control Module
- DTC C13AD-00: Control Module
- DTC C13AE-00: Control Module
- DTC C13AF-00: Control Module
- DTC C13B0-00: Control Module
- DTC C13B1-00: Control Module
- DTC C13B2-00: Control Module
- DTC C13B3-00: Control Module
- DTC C13B4-00: Control Module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
