Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Procedure
- ADAS CONTROL UNIT CONFIGURATION (WITH FEB MODELS)
Perform the ADAS control unit configuration with CONSULT. Refer to Description .
GO TO 2.
- PERFORM SELF-DIAGNOSIS
Perform the self-diagnosis of ADAS control unit with CONSULT. Check if any DTC is detected.
Is any DTC detected?
YES
Perform the trouble diagnosis for the detected DTC. Refer to DTC Index .
NO
INSPECTION END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.