Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2015Q60 BASE, 2D CONVERTIBLEREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER CONTROL SYSTEM (POWER DISTRIBUTION SYSTEM) (CONVERTIBLE)DTC/CIRCUIT DIAGNOSISDTC B2616: IGNITION RELAY CIRCUITDTC LOGICDTC CONFIRMATION PROCEDURE
2015 Infiniti Q60 Base, 2D Convertible
DTC Confirmation Procedure
2015 Infiniti Q60 Base, 2D ConvertibleSECTION DTC Confirmation Procedure
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON under the following conditions, and wait for 1 second or more.
A/T models
- Selector lever is in the P or N position
- Do not depress brake pedal
M/T models
- Do not depress clutch pedal
- Check "Self-diagnostic result" with CONSULT.
Is DTC detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO
INSPECTION END
- Turn ignition switch ON under the following conditions, and wait for 1 second or more.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.