Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2015Q60 BASE, 2D CONVERTIBLEREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEM (VDC/TCS/ABS) (CONVERTIBLE)SYSTEM DESCRIPTIONABSCOMPONENT PARTS LOCATION
2015 Infiniti Q60 Base, 2D Convertible
Component Parts Location
2015 Infiniti Q60 Base, 2D ConvertibleSECTION Component Parts Location
For USA
| 1. | Steering angle sensor | 2. | ABS warning lamp | 3. | Brake warning lamp |
| 4. | VDC OFF indicator lamp | 5. | VDC warning lamp | 6. | ABS actuator and electric unit (control unit) |
| 7. | Front wheel sensor | 8. | Yaw rate/side G sensor | 9. | VDC OFF switch |
| 10. | Rear wheel sensor | ||||
| A. | Back of spiral cable assembly | B. | Combination meter | C. | Inside brake master cylinder cover |
| D. | Steering knuckle | E. | Under center console | F. | Instrument driver lower panel |
| G. | Rear final drive assembly |
Except for USA
| 1. | Steering angle sensor | 2. | ABS warning lamp | 3. | Brake warning lamp |
| 4. | VDC OFF indicator lamp | 5. | VDC warning lamp | 6. | ABS actuator and electric unit (control unit) |
| 7. | Front wheel sensor | 8. | Yaw rate/side G sensor | 9. | VDC OFF switch |
| 10. | Rear wheel sensor | ||||
| A. | Back of spiral cable assembly | B. | Combination meter | C. | Inside brake master cylinder cover |
| D. | Steering knuckle | E. | Under center console | F. | Instrument driver lower panel |
| G. | Rear final drive assembly |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.