Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2015Q60 BASE, 2D CONVERTIBLEREPAIR AND DIAGNOSISBODY & FRAMESEATSAUTOMATIC DRIVE POSITIONER (CONVERTIBLE)DTC/CIRCUIT DIAGNOSISTELESCOPIC SENSORCOMPONENT FUNCTION CHECK
2015 Infiniti Q60 Base, 2D Convertible
Component Function Check
2015 Infiniti Q60 Base, 2D ConvertibleSECTION Component Function Check
- CHECK FUNCTION
- Turn ignition switch ON.
- Select "TELESCO SEN" in the "Data monitor" mode using CONSULT.
- Check the tilt sensor signal under the following conditions.
Monitor item Condition Value TELESCO SEN Telescopic position Change between
0.5 [V] (close to top)
4.5 [V] (close to bottom)
Is the indication normal?
YES
INSPECTION END.
NO
Perform diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.