Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2015Q60 BASE, 2D CONVERTIBLEREPAIR AND DIAGNOSISBODY & FRAMESEATSAUTOMATIC DRIVE POSITIONER (CONVERTIBLE)DTC/CIRCUIT DIAGNOSISSLIDING SENSORCOMPONENT FUNCTION CHECK
2015 Infiniti Q60 Base, 2D Convertible
Component Function Check
2015 Infiniti Q60 Base, 2D ConvertibleSECTION Component Function Check
- CHECK FUNCTION
- Turn ignition switch ON.
- Select "SLIDE PULSE" in the "Data monitor" mode using CONSULT.
- Check sliding sensor signal under the following conditions.
Monitor item Condition Valve SLIDE PULSE Seat sliding Operate (forward) Change (increase)*1 Operate (backward) Change (decrease)*1 Release No change*1 *1 : The value at the seat position attained when the battery is connected is considered to be 32768.
Is the indication normal?
YES
INSPECTION END
NO
Perform diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.