Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013QX56 AWD V8-5.6L (VK56VD)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULETESTING AND INSPECTIONWORK PROCEDUREFOR MEXICO
2013 Infiniti QX56 AWD V8-5.6L (VK56VD)
For Mexico
2013 Infiniti QX56 AWD V8-5.6L (VK56VD)SECTION For Mexico
ADDITIONAL SERVICE WHEN REPLACING ECM
Work Procedure
1. PERFORM INITIALIZATION OF IVIS (NATS) SYSTEM AND REGISTRATION OF ALL IVIS (NATS) IGNITION KEY IDS
Perform initialization of IVIS (NATS) system and registration of all IVIS (NATS) ignition key IDs. Refer to SEC35, "ECM : Work Procedure".
- GO TO 2.
2. PERFORM VIN REGISTRATION
Perform VIN registration. Refer to "Work Procedure" For Mexico.
- GO TO 3.
3. PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform accelerator pedal released position learning. Refer to "Work Procedure" For Mexico.
- GO TO 4.
4. PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
Perform throttle valve closed position learning. Refer to "Work Procedure" For Mexico.
- GO TO 5.
5. PERFORM IDLE AIR VOLUME LEARNING
Perform idle air volume learning. Refer to "Work Procedure" For Mexico.
- END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.