Automatic Back Door Control Module

2013 Infiniti QX56 AWD V8-5.6L (VK56VD)SECTION Automatic Back Door Control Module



AUTOMATIC BACK DOOR CONTROL MODULE

Removal and Installation


REMOVAL

1.Remove the luggage side finisher lower LHD. Refer to "LUGGAGE SIDE LOWER FINISHER : Removal and Installation" Luggage Side Lower Finisher.
2.Remove the automatic back door control unit bracket mounting bolt and nuts, and then remove the automatic back door control unit bracket.
3.Remove the automatic back door control unit mounting bolt, and then remove the automatic back door control unit.

INSTALLATION

Install in the reverse order of removal.
NOTE:
After installing back door control unit, perform additional service when replace control unit. Refer to "ADDITIONAL SERVICE WHEN REPLACING (AUTOMATIC BACK DOOR CONTROL MODULE) : Work Procedure" Work Procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.