Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013QX56 AWD V8-5.6L (VK56VD)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSVARIABLE VALVE TIMING CONTROL MODULESERVICE AND REPAIRFOR MEXICO
2013 Infiniti QX56 AWD V8-5.6L (VK56VD)
For Mexico
2013 Infiniti QX56 AWD V8-5.6L (VK56VD)SECTION For Mexico
VVEL CONTROL MODULE
Removal and Installation
REMOVAL
1.Disconnect VVEL control module harness connector.
2.Remove the fix bolts. And then remove VVEL control module.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Must be perform additional service when replacing VVEL control module. Refer to "Work Procedure" For Mexico.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.