Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013QX56 AWD V8-5.6L (VK56VD)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSINFORMATION BUSTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGCONFIGURATION (CAN GATEWAY)WORK PROCEDURE
2013 Infiniti QX56 AWD V8-5.6L (VK56VD)
Work Procedure
2013 Infiniti QX56 AWD V8-5.6L (VK56VD)SECTION Work Procedure
CONFIGURATION (CAN GATEWAY)
Work Procedure
1. WRITING MODE SELECTION
CONSULT Configuration
Select "CONFIGURATION" of CAN gateway.
When writing saved data-GO TO 2.
When writing manually-GO TO 3.
2. PERFORM "WRITE CONFIGURATION - CONFIG FILE"
CONSULT Configuration
Perform "WRITE CONFIGURATION - Config file".
- GO TO 4.
3. PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
CONSULT Configuration
1.Select "WRITE CONFIGURATION - Manual selection".
2.Select "SETTING".
3.When "COMMAND FINISHED", select "End".
- GO TO 4.
4. CHECK "SELF DIAGNOSTIC RESULT"
1.Erase all ECU self-diagnosis results using CONSULT.
2.Turn the ignition switch OFF.
3.Turn the ignition switch ON and wait for 2 seconds or more.
4.Perform "All DTC Reading" using CONSULT.
5.Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
- WORK END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.