Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013G37 CONVERTIBLE V6-3.7L (VQ37VHR)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGMIXTURE RATIO SELF-LEARNING VALUE CLEARSPECIAL REPAIR REQUIREMENT
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)
Special Repair Requirement
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)SECTION Special Repair Requirement
INSPECTION AND ADJUSTMENT
MIXTURE RATIO SELF-LEARNING VALUE CLEAR : Special Repair Requirement
1. START
With CONSULT
1.Start engine and warm it up to normal operating temperature.
2.Select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT.
3.Clear mixture ratio self-learning value by touching "CLEAR".
With GST
1.Start engine and warm it up to normal operating temperature.
2.Turn ignition switch OFF.
3.Disconnect mass air flow sensor (bank 1) harness connector.
4.Restart engine and let it idle for at least 5 seconds.
5.Stop engine and reconnect mass air flow sensor (bank 1) harness connector.
6.Select Service $03 with GST. Make sure DTC P0102 is detected.
7.Select Service $04 with GST to erase the DTC P0102.
- END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.