Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013G37 CONVERTIBLE V6-3.7L (VQ37VHR)REPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSSERVICE AND REPAIRREMOVAL AND REPLACEMENTFRONT COMBINATION LAMPREMOVAL AND INSTALLATION
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)
Removal and Installation
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)SECTION Removal and Installation
FRONT COMBINATION LAMP
Removal and Installation
REMOVAL
CAUTION:
Disconnect the battery negative terminal or remove the fuse.
1.Remove the front bumper fascia. Refer to "Removal and Installation" Removal and Installation.
2.Remove the mounting bolts.
3.Remove the holding clip (A)* and the harness clip (B).
*: Left side only
4.Pull out the headlamp assembly forward the vehicle.
5.Disconnect the connector before removing the headlamp housing assembly.
INSTALLATION
Install in the reverse order of removal.
NOTE:
After installation, perform aiming adjustment. Refer to "Description" Description.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.