Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013G37 CONVERTIBLE V6-3.7L (VQ37VHR)REPAIR AND DIAGNOSISINSTRUMENT PANEL, GAUGES AND WARNING INDICATORSTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESOFF POSITION WARNING DOES NOT OPERATE
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)
Off Position Warning Does Not Operate
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)SECTION Off Position Warning Does Not Operate
OFF POSITION WARNING DOES NOT OPERATE
Diagnosis Procedure
1. CHECK POWER POSITION
Check if ignition switch position is changing or not.
Does ignition switch position change?
YES- GO TO 2.
NO- Check BCM for DTC. Refer to "DTC Index" Testing and Inspection.
2. CHECK DRIVER SIDE DOOR SWITCH
Check driver side door switch.
Refer to "Component Function Check" Door Switch.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace the malfunctioning parts.
3. CHECK BUZZER (COMBINATION METER)
Check buzzer (combination meter).
Refer to "Component Function Check" Buzzer (Combination Meter).
Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace the malfunctioning parts.
4. CHECK INTELLIGENT KEY WARNING BUZZER
Check Intelligent Key warning buzzer.
Refer to "Component Function Check" Intelligent Key Warning Buzzer.
Is the inspection result normal?
YES- GO TO 5.
NO- Repair or replace the malfunctioning parts.
5. CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES- Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.
NO- GO TO 1.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.