Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013G37 CONVERTIBLE V6-3.7L (VQ37VHR)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGTEMPERATURE SETTING TRIMMER
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)
Temperature Setting Trimmer
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)SECTION Temperature Setting Trimmer
INSPECTION AND ADJUSTMENT
Temperature Setting Trimmer
DESCRIPTION
The trimmer compensates for differences in range of �3�C (�6�F) between temperature setting (displayed digitally) and temperature felt by customer.
Operating procedures for this trimmer are as per the following:
1.Begin self-diagnosis STEP-5 mode. Refer to "Diagnosis Description" Scan Tool Testing and Procedures.
2.Press fan (UP: +) switch to set system in auxiliary mode.
3.Display shows "61" in auxiliary mechanism. It takes approximately 3 seconds to enable setting operation.
4.Turn temperature control dial (driver side) as desired. Temperature will change at a rate of 0.5�C (1.0�F)
each time a dial is turned.
CAUTION:
A decimal point is not indicated on the display.
NOTE:
When battery cable is disconnected or battery voltage is below 10 V, trimmer operation is canceled. Temperature set becomes that of initial condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.