Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013G37 CONVERTIBLE V6-3.7L (VQ37VHR)REPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGSYSTEM SETTINGSPECIAL REPAIR REQUIREMENT
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)
Special Repair Requirement
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)SECTION Special Repair Requirement
INSPECTION AND ADJUSTMENT
SYSTEM SETTING : Special Repair Requirement
SETTING PROCEDURE
1. STEP-1
Set the vehicle to the following condition.
- Ignition position: ACC
- A/T selector lever: P position (A/T models)
- Parking brake: Applied only (M/T models)
- GO TO 2.
2. STEP-2
Press set switch and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Seat synchronization are ON : Memory switch indicator blink two times.
- Seat synchronization are OFF : Memory switch indicator blink once.
NOTE:
- After memory setting registration, by pushing set switch for approximately 10 seconds, memory switch indicator lamp turns 4 seconds. turns OFF, blinks 1 or 2 times, and then the switching operation is complete.
Push and hold set switch during the switching operation.
- END.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.