Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2013G37 CONVERTIBLE V6-3.7L (VQ37VHR)REPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSMEMORY POSITIONING SYSTEMSDESCRIPTION AND OPERATIONPOWER WALK-IN FUNCTIONSYSTEM DESCRIPTION
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)
System Description
2013 Infiniti G37 Convertible V6-3.7L (VQ37VHR)SECTION System Description
AUTOMATIC DRIVE POSITIONER SYSTEM
POWER WALK-IN FUNCTION : System Description
OUTLINE
Slide the driver seat automatically with the power walk-in switch operation so as to easily facilitate the entry to the rear seat.
Forward Operation
Slide (forward) the driver seat to the front end position (sliding limit switch: ON) by operating the power walk-in switch when the seatback is folded down.
The forward operation is stopped by folding the seatback (forward switch: OFF) during the forward operation.
Backward Operation
The seat back is folded up after performing the forward operation of power walk-in function. Slide (backward)
it to the position before performing the forward operation by operating the power walk-in switch.
If the manual operation, memory operation, and Intelligent Key interlock operation are performed after performing the forward operation, do not perform the backward operation.
OPERATION PROCEDURE
Forward Operation
1.Open driver door.
2.Pull the walk-in lever on the upper part of seatback, and then the seatback is folded down.
3.Press the power walk-in switch.
4.Slide the seat to the front end position.
Backward Operation
1.Open driver door.
2.Fold up the seatback after performing the forward operation.
3.Press the power walk-in switch.
4.Slide the seat to the previous position before the forward operation was performed.
OPERATION CONDITION
Perform the power walk-in function when the following conditions are satisfied.
Forward Operation
Backward Operation
DETAIL FLOW
Forward Operation
Backward Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.