Meter System

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with two communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.
CAN Communication Signal Chart. Refer to "CAN Communication Signal Chart" CAN Communication Signal Chart.


DTC Logic


DTC DETECTION LOGIC








Diagnosis Procedure


1. PERFORM SELF DIAGNOSTIC

1.Turn ignition switch ON and wait for 2 seconds or more.
2.Check "Self Diagnostic Result" of "METER/M&A".
Is "CAN COMM CIRCUIT" displayed?
YES- Refer to "Trouble Diagnosis Flow Chart" Trouble Diagnosis Flow Chart.
NO- Refer to "Intermittent Incident" Intermittent Incident.