Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2012M56 V8-5.6L (VK56VD)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINS
2012 Infiniti M56 V8-5.6L (VK56VD)
Computers and Control Systems: Technical Service Bulletins
2012 Infiniti M56 V8-5.6L (VK56VD)SECTION Technical Service Bulletins
- Recalls
- Customer Interest
- 12-026B - 03/29/2013
- Engine Controls - MIL ON, A/F Sensor Related DTC's Stored
- Engine Controls - No Start/Low Battery Voltage
- Engine, A/T Controls - Hesitation On Acceleration/Harsh Shiftin
- Engine Controls - ECM Replacement Procedure
- Engine Controls - MIL ON/DTC P0300 Is Stored In ECM
- Engine Controls - MIL ON, Paired Inj. DTC's, Runs Rough
- Engine Controls - Intake Air Volume Learn Won't Complete
- By Symptom
- Customer Interest
- 12-026B - 03/29/2013
- Engine Controls - MIL ON, A/F Sensor Related DTC's Stored
- Engine Controls - No Start/Low Battery Voltage
- Engine, A/T Controls - Hesitation On Acceleration/Harsh Shiftin
- Engine Controls - ECM Replacement Procedure
- Engine Controls - MIL ON/DTC P0300 Is Stored In ECM
- Engine Controls - MIL ON, Paired Inj. DTC's, Runs Rough
- Engine Controls - Intake Air Volume Learn Won't Complete
- Hard Shifting
- Low, Dead battery
- Recalls
- Starting problems
- Customer Interest
- All Technical Service Bulletins
- Computers/Controls - CAN Communication Diagnostic Flow Chart
- 12-026B - 03/29/2013
- Emissions - EVAP Leak Diagnosis
- Engine Controls - MIL ON, A/F Sensor Related DTC's Stored
- Engine Controls - No Start/Low Battery Voltage
- Engine, A/T Controls - Hesitation On Acceleration/Harsh Shiftin
- Emissions - System Readiness Test (SRT) Drive Patterns
- Computers/Controls - CONSULT III PLUS(R) Saved Data List
- Body Controls - Configurable BCM Replacement Information
- Engine Controls - ECM Replacement Procedure
- Engine Controls - MIL ON/DTC P0300 Is Stored In ECM
- Engine Controls - MIL ON, Paired Inj. DTC's, Runs Rough
- Engine Controls - Intake Air Volume Learn Won't Complete
- Computers/Controls - Reprogramming Utilizing CONSULT(R)
- Recall R1202 - Fuel Rail Pressure Sensor Torque Inspection
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.