Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2012M56 V8-5.6L (VK56VD)REPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSDESCRIPTION AND OPERATIONSEAT SYNCHRONIZATION FUNCTIONSYSTEM DESCRIPTION
2012 Infiniti M56 V8-5.6L (VK56VD)
System Description
2012 Infiniti M56 V8-5.6L (VK56VD)SECTION System Description
SYSTEM
SEAT SYNCHRONIZATION FUNCTION : System Description
The steering column position and door mirror position is adjusted to the position automatically according to the direction and distance of seat movement when performing the manual operation of sliding, reclining or lifting (rear). This function saves adjusting the mirror and steering column when adjusting the seat.
NOTE:
- This function is set to OFF before delivery (initial setting).
- For the system setting procedure. Description.
OPERATION PROCEDURE
1.Turn ignition switch ON.
2.Adjust seat position [sliding, reclining, lifting (rear)].
3.The steering and outside mirror is adjusted automatically.
NOTE:
- The seat synchronization function will not operate if seat adjusting value is more than limit value.
- The seat synchronization function will not operate if the steering column or door mirror moves to the operating end while this function is operating. Perform memory function or drive the vehicle at vehicle speed of 7
km/h or more once to activate this function again.
- If the seat position is uncomfortable after the adjustment, seat position can be adjusted easily by memory operation.
OPERATION CONDITION
Satisfy all of the following items. The seat synchronization function is not performed if these items are not satisfied.
DETAIL FLOW
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.