Special Repair Requirement

INSPECTION AND ADJUSTMENT

SYSTEM SETTING : Special Repair Requirement


1. CHOOSE METHOD

There are three way of setting method.
Which method do you choose?
With CONSULT-GO TO 2.
With set switch-GO TO 4.

2. WITH CONSULT - STEP 1

Select "Work support".
- GO TO 3.

3. WITH CONSULT - STEP 2

1.Select "EXIT SEAT SLIDE SETTING", or "EXIT TILT SETTING" then touch display to change between ON
and OFF.
-EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
-EXIT TILT SETTING: Entry/exit assist (steering column)
2.Select "SEAT SLIDE VOLUME SET" and touch either of "40 mm", "80 mm", or "150 mm".
3.Then touch "OK".
- END

4. WITH SET SWITCH - STEP 1

1.Turn ignition switch OFF.
2.Push setting button and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Entry/exit assist (seat/steering column) are ON: Memory switch indicator blink two times.
- Entry/exit assist (seat/steering column) are OFF: Memory switch indicator blink once.
- GO TO 5.

5. WITH SET SWITCH - STEP 2

1.Turn ignition switch ACC
2.Push setting button and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Seat synchronization are ON: Memory switch indicator blink two times.
- Seat synchronization are OFF: Memory switch indicator blink once.
- END