Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Special Repair Requirement
2012 Infiniti M56 V8-5.6L (VK56VD)SECTION Special Repair Requirement
INSPECTION AND ADJUSTMENT
SYSTEM INITIALIZATION : Special Repair Requirement
INITIALIZATION PROCEDURE
1. CHOOSE METHOD
There are two initialization methods.
Which method do you use?
With door switch-GO TO 2.
With vehicle speed-GO TO 4.
2. STEP A-1
Turn ignition switch from ACC to OFF position.
- GO TO 3.
3. STEP A-2
Driver door switch is ON (open) -> OFF (close) -> ON (open).
- END
4. STEP B-1
Drive the vehicle at more than 25 km/h (16 MPH).
- END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.