Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2012M56 V8-5.6L (VK56VD)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTGLOBAL POSITIONING SYSTEMTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSMULTI AV SYSTEM - CONFIGURATION AFTER REPLACING CONTROL UNITOVERVIEW
2012 Infiniti M56 V8-5.6L (VK56VD)
Multi AV System - Configuration After Replacing Control Unit: Overview
2012 Infiniti M56 V8-5.6L (VK56VD)SECTION Overview
Classification: 10-009B
Reference: ITB10-017B
Date: March 14, 2012
AV CONTROL UNIT REPLACEMENT REQUIRES CONSULT-III PLUS CONFIGURATION
This bulletin has been amended. The Applied Vehicles and Service Procedure sections have been revised. Please discard previous versions.
APPLIED VEHICLES: 2010-2012 EX35 (J50)
2010-2012 FX35/FX50 (S51)
2010-2012 G37 Coupe, Convertible, and Sedan (C/H/V36)
2013 JX35 (L50)
2011-2012 M37/M56 and 2012 M35 Hybrid (H/Y51)
2011-2012 QX56 (Z62)
SERVICE INFORMATION
If the AV Control Unit needs to be replaced on an Applied Vehicle for any reason, follow the steps in the Service Procedure to configure the Multi AV system.
NOTE:
The original AV Control Unit must be installed in the vehicle while performing part of this procedure. DO NOT remove the original AV Control Unit until instructed.
Reference: ITB10-017B
Date: March 14, 2012
AV CONTROL UNIT REPLACEMENT REQUIRES CONSULT-III PLUS CONFIGURATION
This bulletin has been amended. The Applied Vehicles and Service Procedure sections have been revised. Please discard previous versions.
APPLIED VEHICLES: 2010-2012 EX35 (J50)
2010-2012 FX35/FX50 (S51)
2010-2012 G37 Coupe, Convertible, and Sedan (C/H/V36)
2013 JX35 (L50)
2011-2012 M37/M56 and 2012 M35 Hybrid (H/Y51)
2011-2012 QX56 (Z62)
SERVICE INFORMATION
If the AV Control Unit needs to be replaced on an Applied Vehicle for any reason, follow the steps in the Service Procedure to configure the Multi AV system.
NOTE:
The original AV Control Unit must be installed in the vehicle while performing part of this procedure. DO NOT remove the original AV Control Unit until instructed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.