Component Inspection (ASCD Clutch Switch)

2012 Infiniti G37 Sport, 2D CoupeSECTION Component Inspection (ASCD Clutch Switch)
  1. CHECK ASCD CLUTCH SWITCH-I
    1. Turn ignition switch OFF.
    2. Disconnect ASCD clutch switch harness connector.
    3. Check the continuity between ASCD clutch switch terminals under the following conditions.
      Terminals Condition Continuity
      1 and 2 Clutch pedal Fully released Existed
      Slightly depressed Not existed

      Is the inspection result normal?Β 

      YES: INSPECTION END

      NO: GO TO 2.

  2. CHECK ASCD CLUTCH SWITCH-II
    1. Adjust ASCD clutch switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
    2. Check the continuity between ASCD clutch switch terminals under the following conditions.
      Terminals Condition Continuity
      1 and 2 Clutch pedal Fully released Existed
      Slightly depressed Not existed

      Is the inspection result normal?Β 

      YES: INSPECTION END

      NO: Replace ASCD clutch switch. Refer to "EXPLODED VIEW ".

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.