Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2011M56 V8-5.6L (VK56VD)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSERVICE PRECAUTIONSINFINITI DRIVE MODE SELECTOR
2011 Infiniti M56 V8-5.6L (VK56VD)
Infiniti Drive Mode Selector
2011 Infiniti M56 V8-5.6L (VK56VD)SECTION Infiniti Drive Mode Selector
HANDLING PRECAUTION
Infiniti Drive Mode Selector
ECO DRIVE INDICATOR LAMP CONTROL
- ECO drive indicator turns OFF under the following conditions.
- While driving at low speeds [3 MPH (4.8 km/h) or less] or high speeds [90 MPH (144 km/h) or more].
- Intelligent cruise control is in operation.
- Selector lever is in R range.
ECO PEDAL CONTROL
- When switching from ECO mode to the other mode by operating the drive mode select switch, ECO pedal reaction force is generated in common with ECO mode until the accelerator pedal is released.
- ECO pedal reaction force is not generated under the following conditions.
- Intelligent cruise control is in operation.
- Accelerator pedal is depressed quickly.
- Selector lever is in N or R range.
- ECO pedal reaction force setting is OFF.
NOTE:
ECO pedal control is only for vehicles with an intelligent pedal (distance control assist).
ENGINE OUTPUT CHARACTERISTICS AFTER SWITCHING MODE
- Engine output characteristics after switching mode by operating the drive mode select switch are as follows.
- After switching mode to a mode that engine output increase, engine output characteristics are changed by releasing the accelerator pedal.
- After switching mode to a mode that engine output decreases, engine output characteristics are changed immediately.
- When an accelerator angle is constant, engine output characteristics are as follows.
- SPORT ] STANDARD ] ECO ] SNOW
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.