Check CAN Communication System

2009 Infiniti M35x AWD V6-3.5L (VQ35HR)SECTION Check CAN Communication System




INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION


Check CAN Communication System

1.CHECK SELF-DIAGNOSTIC RESULTS

CAUTION:
If CONSULT-III is used with no connection of CONSULT-III CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which performs CAN communication.

With CONSULT-III
- Connect CONSULT-III, and turn ignition switch ON.
- Touch "INTELLIGENT KEY" on "SELECT SYSTEM" screen.
- Touch "SELF-DIAG RESULTS" on "SELECT DIAG MODE" screen.
- Check display content in self-diagnostic results.





OK or NG
NO DTC IS DETECTED INSPECTION END
CAN COMM CIRCUIT [U1000] After printing "SELF-DIAGNOSIS RESULTS", go to "CAN SYSTEM", Refer to Precautions For Trouble Diagnosis
CONTROL UNIT(CAN) [U1010] Replace Intelligent Key unit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.