Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2009M35X AWD V6-3.5L (VQ35HR)REPAIR AND DIAGNOSISBODY AND FRAMEBODY CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIR
2009 Infiniti M35x AWD V6-3.5L (VQ35HR)
Body Control Module: Service and Repair
2009 Infiniti M35x AWD V6-3.5L (VQ35HR)SECTION Service and Repair
BCM (BODY CONTROL MODULE)
Removal and Installation of BCM
REMOVAL
1. Remove glove box cover. Refer to Instrument Panel.
2. Remove screws (A), and pull out the BCM (1).
3. Disconnect connector.
4. Remove BCM (1).
INSTALLATION
Installation is the reverse order of removal.
NOTE:
When replacing BCM perform initialization of NATS system and registration of all NATS ignition key IDs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.