Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2009M35X AWD V6-3.5L (VQ35HR)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTENTERTAINMENT SYSTEMSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSRGB (G GREEN) SIGNAL CIRCUIT (AV CONTROL UNIT TO FRONT DISPLAY UNIT)WITH MOBILE ENTERTAINMENT SYSTEMDIAGNOSIS PROCEDURE
2009 Infiniti M35x AWD V6-3.5L (VQ35HR)
Diagnosis Procedure
2009 Infiniti M35x AWD V6-3.5L (VQ35HR)SECTION Diagnosis Procedure
RGB (G: GREEN) SIGNAL CIRCUIT (AV CONTROL UNIT TO FRONT DISPLAY UNIT)
Diagnosis Procedure
1.CHECK CONTINUITY RGB (G: GREEN) SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front display unit connector and AV control unit connector.
3. Check continuity between front display unit harness connector terminal 6 and AV control unit harness connector terminal 94.
6 - 94 : Continuity should exist.
4. Check continuity between front display unit harness connector terminal 6 and ground.
6 - Ground : Continuity should not exist.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair harness or connector.
2.CHECK RGB (G: GREEN) SIGNAL
1. Connect front display unit connector and AV control unit connector.
2. Turn ignition switch ON.
3. Check signal between front display unit harness connector terminal 6 and ground.
Is the inspection result normal?
YES - Replace front display unit.
NO - Replace AV control unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.