Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2008FX45 AWD V8-4.5L (VK45DE)REPAIR AND DIAGNOSISMAINTENANCEFLUIDSFLUID - TRANSFER CASESERVICE AND REPAIR
2008 Infiniti FX45 AWD V8-4.5L (VK45DE)
Fluid - Transfer Case: Service and Repair
2008 Infiniti FX45 AWD V8-4.5L (VK45DE)SECTION Service and Repair
DRAINING
1. Run the vehicle to warm up the transfer unit sufficiently.
2. Stop the engine, and remove the drain plug to drain the transfer fluid.
3. Apply sealant to drain plug. Install drain plug on transfer and tighten to the specified torque.
^ Use Genuine Silicone RTV or equivalent.
FILLING
1. Remove filler plug and add transfer fluid until fluid level reaches the specified limit near filler plug mounting hole.
Fluid and viscosity: Refer to MA-9, "Fluids and Lubricants".
Fluid capacity: Approx. 1.25 l (2 - 5/8 US pt, 2 - 1/4 Imp pt)
CAUTION: Carefully fill the fluid. (Fill up for approx. 3 minutes.)
2. Leave the vehicle for 3 minutes, and check the fluid level again.
3. Set a new gasket onto filler plug and install it on transfer and tighten to the specified torque.
CAUTION: Do not reuse gasket.
1. Run the vehicle to warm up the transfer unit sufficiently.
2. Stop the engine, and remove the drain plug to drain the transfer fluid.
3. Apply sealant to drain plug. Install drain plug on transfer and tighten to the specified torque.
^ Use Genuine Silicone RTV or equivalent.
FILLING
1. Remove filler plug and add transfer fluid until fluid level reaches the specified limit near filler plug mounting hole.
Fluid and viscosity: Refer to MA-9, "Fluids and Lubricants".
Fluid capacity: Approx. 1.25 l (2 - 5/8 US pt, 2 - 1/4 Imp pt)
CAUTION: Carefully fill the fluid. (Fill up for approx. 3 minutes.)
2. Leave the vehicle for 3 minutes, and check the fluid level again.
3. Set a new gasket onto filler plug and install it on transfer and tighten to the specified torque.
CAUTION: Do not reuse gasket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.