Campaign P0332 - Speedometer/Odometer Programming Error: Overview

2008 Infiniti FX45 AWD V8-4.5L (VK45DE)SECTION Overview
Reference: ITB10-065

Date: October 21, 2010

VOLUNTARY SERVICE CAMPAIGN
2007-2008 FX WITH ICC SPEEDOMETER AND ODOMETER PROGRAMMING ERROR

CAMPAIGN ID#: P0332

APPLIED VEHICLES: 2007 - 2008 FX (S50) with Intelligent Cruise Control (ICC)

Check Service Comm to confirm campaign eligibility

INTRODUCTION

On certain model year 2007 and 2008 Infiniti FX vehicles the speedometer and odometer are reading out of specification. To remedy this condition Infiniti is conducting this voluntary service campaign to replace the Intelligent Cruise Control (ICC) unit and recalibrate the speedometer and odometer at no charge for parts or labor.

IDENTIFICATION NUMBER

Infiniti has assigned identification number P0332 to this campaign. This number must appear on all communications and documentation of any nature dealing with this campaign.

DEALER RESPONSIBILITY

Dealers are to correct each vehicle falling within the range of this campaign that enters the service department. This includes vehicles purchased from private parties or presented by transient (tourist) owners and vehicles in a dealer's inventory.

The mileage on this claim should reflect the correct and updated milage after the odometer recalibration is complete. Refer to Claims Information for additional details.





REQUIRED SPECIAL TOOL - Meter Reprogramming Kit (J-50419)





REPAIR OVERVIEW





PARTS INFORMATION





CLAIMS INFORMATION



RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.