Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnosis Description: Introduction
The ECM has an on board diagnostic system, which detects malfunctions related to engine sensors or actuators. The ECM also records various emission-related diagnostic information including:
| Emission-related diagnostic information | Diagnostic service |
|---|---|
| Diagnostic Trouble Code (DTC) | Service $03 of SAE J1979 |
| Freeze Frame data | Service $02 of SAE J1979 |
| System Readiness Test (SRT) code | Service $01 of SAE J1979 |
| 1st Trip Diagnostic Trouble Code (1st Trip DTC) | Service $07 of SAE J1979 |
| 1st Trip Freeze Frame data | - |
| Test values and Test limits | Service $06 of SAE J1979 |
| Calibration ID | Service $09 of SAE J1979 |
The above information can be checked using procedures listed in the table below.
| x: Applicable -: Not applicable | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| DTC | 1st trip DTC | Freeze Frame data | 1st trip Freeze Frame data | SRT code | SRT status | Test value | |||
| CONSULT-III | x | x | x | x | x | x | - | ||
| GST | x | x | x | - | x | x | x | ||
| ECM | x | x(1) | - | - | - | x | - | ||
|
|||||||||
The malfunction indicator lamp (MIL) on the instrument panel lights up when the same malfunction is detected in two consecutive trips (Two trip detection logic), or when the ECM enters fail-safe mode. (Refer to "FAIL SAFE ".)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.