SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2008EX35 BASE, AWDREPAIR AND DIAGNOSISELECTRICALMOTORS, SWITCHES, RELAYSPOWER CONTROL SYSTEMPOWER DISTRIBUTION SYSTEMECU DIAGNOSISBCM (BODY CONTROL MODULE)REFERENCE VALUEPHYSICAL VALUES
2008 Infiniti EX35 Base, AWD

Physical Values

2008 Infiniti EX35 Base, AWDSECTION Physical Values
PHYSICAL VALUES

Terminal No.
(Wire color)		 Description Condition Value (Approx.)
+ - Signal name Input/Output
1 (W) Ground Battery power supply Input Ignition switch OFF Battery voltage
2 (Y) Ground P/W power supply (BAT) Output Ignition switch OFF Battery voltage
3 (O) Ground P/W power supply (RAP) Output Ignition switch ON Battery voltage
4 (LG) Ground Interior room lamp power supply Output Interior room lamp battery saver is activated.
(Cuts the interior room lamp power supply)		 0 V
Interior room lamp battery saver is not activated.
(Outputs the interior room lamp power supply)		 Battery voltage
5 (L) Ground Passenger door UNLOCK Output Passenger door UNLOCK
(Actuator is activated)		 Battery voltage
Other than UNLOCK
(Actuator is not activated)		 0 V
7 (Y) Ground Step lamp Output Step lamp ON 0 V
OFF Battery voltage
8 (V) Ground All doors, fuel lid LOCK Output All doors LOCK
(Actuator is activated)		 Battery voltage
Other than LOCK
(Actuator is not activated)		 0 V
9 (G) Ground Driver door, fuel lid UNLOCK Output Driver door UNLOCK
(Actuator is activated)		 Battery voltage
Other than UNLOCK
(Actuator is not activated)		 0 V
10 (BR) Ground Rear RH door and rear LH door UNLOCK Output Rear RH door and rear LH door UNLOCK
(Actuator is activated)		 Battery voltage
Other than UNLOCK
(Actuator is not activated)		 0 V
11 (R) Ground Battery power supply Input Ignition switch OFF Battery voltage
13 (B) Ground Ground - Ignition switch ON 0 V
14 (W) Ground Push-button ignition switch illumination ground Output Tail lamp OFF 0 V
ON
NOTE: When the illumination brightening/dimming level is in the neutral position
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.