Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2008EX35 AWD V6-3.5L (VQ35HR)REPAIR AND DIAGNOSISLIGHTING AND HORNSCOURTESY LAMPSERVICE AND REPAIRPERSONAL LAMP
2008 Infiniti EX35 AWD V6-3.5L (VQ35HR)
Personal Lamp
2008 Infiniti EX35 AWD V6-3.5L (VQ35HR)SECTION Personal Lamp
PERSONAL LAMP
Exploded View
NOTE: Replace the personal lamp case as a set (right and left). After removing the headlining assembly, remove the personal lamp case.
Removal and Installation
CAUTION: Disconnect the battery negative terminal or remove the fuse.
REMOVAL
1. Remove the headlining assembly.
2. Insert any appropriate tool into the gap between the lens. Remove the lens.
4. Remove the personal lamp case from the headlining assembly.
NOTE: Replace the personal lamp case as a set (right and left).
INSTALLATION
Install in the reverse order of removal.
NOTE: The following is easier to install the personal lamp finisher.
Replacement
CAUTION:
- Disconnect the battery negative terminal or remove the fuse.
- Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it. Never touch bulb by hand while it is lit or right after being turned off.
- Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.
Exploded View
INL-107 Exploded View:
NOTE: Replace the personal lamp case as a set (right and left). After removing the headlining assembly, remove the personal lamp case.
Removal and Installation
CAUTION: Disconnect the battery negative terminal or remove the fuse.
REMOVAL
1. Remove the headlining assembly.
2. Insert any appropriate tool into the gap between the lens. Remove the lens.
4. Remove the personal lamp case from the headlining assembly.
NOTE: Replace the personal lamp case as a set (right and left).
INSTALLATION
Install in the reverse order of removal.
NOTE: The following is easier to install the personal lamp finisher.
Replacement
CAUTION:
- Disconnect the battery negative terminal or remove the fuse.
- Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it. Never touch bulb by hand while it is lit or right after being turned off.
- Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.