Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2008EX35 AWD V6-3.5L (VQ35HR)REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSSERVICE PRECAUTIONSTECHNICIAN SAFETY INFORMATIONHARNESS REPAIR
2008 Infiniti EX35 AWD V6-3.5L (VQ35HR)
Harness Repair
2008 Infiniti EX35 AWD V6-3.5L (VQ35HR)SECTION Harness Repair
Precautions for Harness Repair
COMMUNICATION LINE
^ Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
^ Bypass connection is never allowed at the repaired area.
NOTE:
Bypass connection may cause communication error as spliced wires that are separate from the main line or twisted lines lose noise immunity.
^ Replace the applicable harness as an assembly if error is detected on the shield lines of communication line.
COMMUNICATION LINE
^ Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
^ Bypass connection is never allowed at the repaired area.
NOTE:
Bypass connection may cause communication error as spliced wires that are separate from the main line or twisted lines lose noise immunity.
^ Replace the applicable harness as an assembly if error is detected on the shield lines of communication line.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.