Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2008EX35 AWD V6-3.5L (VQ35HR)REPAIR AND DIAGNOSISBODY AND FRAMESEATSPOWER SEAT CONTROL MODULESERVICE AND REPAIRDRIVER SEAT CONTROL UNIT
2008 Infiniti EX35 AWD V6-3.5L (VQ35HR)
Driver Seat Control Unit
2008 Infiniti EX35 AWD V6-3.5L (VQ35HR)SECTION Driver Seat Control Unit
ON-VEHICLE REPAIR
DRIVER SEAT CONTROL UNIT
Removal and Installation
REMOVAL
CAUTION: When removing and installing, use shop cloths to protect parts from damage.
1. Remove the driver seat (1).
2. Remove the mounting bolts (A).
3. Remove driver seat control unit (2).
INSTALLATION
Install in the reverse order of removal.
CAUTION: Be sure to clump the harness to the right place.
NOTE: After installing the driver seat, perform additional service when replacing control unit. Refer to ADP-8, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description". Additional Service When Removing Battery Negative Terminal
DRIVER SEAT CONTROL UNIT
Removal and Installation
REMOVAL
CAUTION: When removing and installing, use shop cloths to protect parts from damage.
1. Remove the driver seat (1).
2. Remove the mounting bolts (A).
3. Remove driver seat control unit (2).
INSTALLATION
Install in the reverse order of removal.
CAUTION: Be sure to clump the harness to the right place.
NOTE: After installing the driver seat, perform additional service when replacing control unit. Refer to ADP-8, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description". Additional Service When Removing Battery Negative Terminal
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.