Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006G35 BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESDRIVER INFORMATION SYSTEM (COUPE)
2006 Infiniti G35 Base, 2D Coupe, Automatic
Driver Information System (Coupe)
2006 Infiniti G35 Base, 2D Coupe, AutomaticSECTION Driver Information System (Coupe)
- Precaution
- Combination Meters
- System Description
- Component Parts and Harness Connector Location
- Arrangement of Combination Meter
- Schematic
- Wiring Diagram - METER -
- Terminals and Reference Value for Combination Meter
- Self-Diagnosis Mode of Combination Meter
- Trouble Diagnosis
- Symptom Chart
- Power Supply and Ground Circuit Inspection
- Vehicle Speed Signal Inspection
- Engine Speed Signal Inspection
- Engine Coolant Temperature Signal Inspection
- Fuel Level Sensor Signal Inspection
- Fuel Gauge Pointer Fluctuates, Indicator Wrong Value or Varies
- Fuel Gauge Does Not Move to FULL position
- Electrical Components Inspection
- Removal and Installation for Combination Meter
- Disassembly and Assembly for Combination Meter
- Warning Lamps
- A/T Indicator
- Warning Chime
- System Description
- Component Parts and Harness Connector Location
- Schematic
- Wiring Diagram - CHIME -
- Terminals and Reference Value for BCM
- CONSULT-II Function (BCM)
- Trouble Diagnosis
- Symptom Chart
- Power Supply and Ground Circuit Inspection
- Combination Meter Buzzer Circuit Inspection
- Driver Side Door Switch Signal Inspection
- Key Switch Signal Inspection (Without Intelligent Key)
- Key Switch and Ignition Knob Switch Signal Inspection (With Intelligent Key, When Mechanical Key Is Used)
- Lighting Switch Signal Inspection
- Seat Belt Buckle Switch (Driver Side) Signal Inspection
- Component Inspection
- Can Communication
- Compass
- System Description
- Wiring Diagram - COMPASS -
- Fail-Safe System
- Power Supply and Ground Circuit Inspection
- Compass Does not Display
- Compass Display "- - -"
- Forward Direction Indication Slips Off The Mark or Incorrect
- Compass Reading Remains Unchanged
- Calibration Procedure for Compass
- Removal and Installation of Compass
- Clock
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.