SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006G35 BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATS (COUPE)AUTOMATIC DRIVE POSITIONERCHECK SLIDING LIMIT SWITCH SIGNAL
2006 Infiniti G35 Base, 2D Coupe, Automatic

Check Sliding Limit Switch Signal

2006 Infiniti G35 Base, 2D Coupe, AutomaticSECTION Check Sliding Limit Switch Signal
  1. CHECK SLIDING LIMIT SWITCH SIGNAL 

    When operation condition consists, check voltage between driver seat control unit connector B352 terminal 4 and ground.

    VOLTAGE CHECK TABLE

    Connector Terminals Condition Voltage (V) (Approx.)
    (+) (-)
    B352 4 (OR) Ground The seat slide front most part 0
    Other than above 5

    OK or NG 

    OK: Sliding limit switch (forward) signal is OK.

    NG: GO TO 2.

    Fig 1: Checking Voltage Between Driver Seat Control Unit Connector Terminal 4 And Ground
    G04182641Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK HARNESS CONTINUITY 
    1. Disconnect driver seat control unit and sliding limit switch connector.
    2. Check continuity between driver seat control unit connector B352 terminal 4 and sliding limit switch connector B329 terminal 1.

      4 (OR) - 1 (OR): Continuity should exist  .

    OK or NG 

    OK: GO TO 3.

    NG: Repair or replace harness between driver seat control unit and sliding limit switch.

    Fig 2: Checking Continuity Between Driver Seat Control Unit And Sliding Limit Switch Connector Terminals
    G04182642Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK SLIDING LIMIT SWITCH CIRCUIT 

    Check continuity between sliding limit switch connector B329 terminal 2 and ground.

    2 (B) - Ground: Continuity should exist  .

    OK or NG 

    OK: GO TO 4.

    NG: Repair or replace harness.

    Fig 3: Checking Continuity Between Sliding Limit Switch Connector Terminal 2 And Ground
    G04182643Courtesy of NISSAN MOTOR CO., U.S.A.
  4. CHECK SLIDING LIMIT SWITCH 

    Check continuity between sliding limit switch connector B329 terminals 1 and 2.

    CONTINUITY CHECK TABLE

    Connector Terminal Condition Continuity
    B329 1 2 When sliding limit switch fully front Yes
    Other than above No

    OK or NG 

    OK: Check the condition of the harness and the connector.

    NG: Replace sliding limit switch.

    Fig 4: Check Continuity Between Sliding Limit Switch Connector B329 Terminals 1 And 2
    G04182644Courtesy of NISSAN MOTOR CO., U.S.A.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.