SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSMISSIONON-VEHICLE SERVICEREVOLUTION SENSOR COMPONENTS (2WD MODELS ONLY)REMOVAL
2006 Infiniti FX35 AWD

Revolution Sensor Components (2WD Models Only): Removal

2006 Infiniti FX35 AWDSECTION Removal
  1. Disconnect the battery cable from the negative terminal.
  2. Drain ATF through drain plug.
  3. Remove front cross bar. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove exhaust front tube and center muffler with power tool. Refer to "COMPONENTS ".
  5. Remove rear propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
  6. Remove control rod. Refer to "CONTROL ROD REMOVAL AND INSTALLATION ".
  7. Remove oil pan and oil pan gasket.
    Fig 1: Identifying Oil Pan Bolts
    G04075672Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Check foreign materials in oil pan to help determine causes of malfunction. If the ATF is very dark, smells burned, or contains foreign particles, the frictional material (clutches, band) may need replacement. A tacky film that will not wipe clean indicates varnish build up. Varnish can cause valves, servo, and clutches to stick and can inhibit pump pressure.
    Fig 2: Checking A/T Fluid For Foreign Materials
    G04081632Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Support A/T assembly with a transmission jack.
    CAUTION: When setting transmission jack, place wooden blocks to prevent from damaging control valve with TCM and transmission case.
  10. Remove rear engine mounting member with power tool. Refer to "REMOVAL AND INSTALLATION (2WD MODELS) ".
  11. Remove tightening bolts for rear extension assembly and transmission case.
    Fig 3: Identifying Tightening Bolts For Rear Extension Assembly And Transmission Case
    G04075718Courtesy of NISSAN MOTOR CO., U.S.A.
  12. Tap rear extension assembly with soft hammer.
    Fig 4: Taping Rear Extension Assembly With Soft Hammer
    G04075719Courtesy of NISSAN MOTOR CO., U.S.A.
  13. Remove rear extension assembly from transmission case. (With needle bearing.)
    Fig 5: Removing Rear Extension Assembly From Transmission Case
    G04075720Courtesy of NISSAN MOTOR CO., U.S.A.
  14. Disconnect revolution sensor connector.
    CAUTION: Be careful not to damage connector
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.