Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Erase DTC (No Tools)
2006 Infiniti FX35 AWDSECTION How To Erase DTC (No Tools)
The A/T CHECK indicator lamp is located on the instrument panel.
- If the ignition switch stays ON after repair work, be sure to turn ignition switch OFF once. Wait at least 10 seconds and then turn it ON (engine stopped) again.
- Perform "TCM SELF-DIAGNOSTIC PROCEDURE (No Tools)". Refer to "TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS) ". (The engine warm-up step can be skipped when performing the diagnosis only to erase the DTC.)
- Perform "OBD-II SELF-DIAGNOSTIC PROCEDURE (No tools)". Refer to "HOW TO ERASE DTC " (for VQ35DE) or "HOW TO ERASE DTC " (for VK45DE).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.