Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSMISSIONDTC P0700: TCMDIAGNOSTIC PROCEDURE
2006 Infiniti FX35 AWD
Diagnostic Procedure
2006 Infiniti FX35 AWDSECTION Diagnostic Procedure
- CHECK DTC
With CONSULT-II
- Turn ignition switch ON. (Do not start engine.)
- Select "SELF DIAG RESULTS" mode for "A/T" with CONSULT-II.
- Touch "ERASE".
- Turn ignition switch OFF and wait at least 10 seconds.
- Perform "DTC CONFIRMATION PROCEDURE ".
Is the "P0700 TCM" displayed again?
YES : Replace the control valve with TCM. Refer to "CONTROL VALVE WITH TCM AND A/T FLUID TEMPERATURE SENSOR 2 ".
NO : INSPECTION END .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.