Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Generic Scan Tool (GST) Function: Function
2006 Infiniti FX35 AWDSECTION Function
WARNING: This page is about a different car, the 2006 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
GENERIC SCAN TOOL (GST) FUNCTION
| Diagnostic service | Function | |
|---|---|---|
| Service $01 | READINESS TESTS | This mode gains access to current emission-related data values, including analog inputs and outputs, digital inputs and outputs, and system status information. |
| Service $02 | (FREEZE DATA) | This mode gains access to emission-related data value which were stored by ECM during the freeze frame. For details, refer to "FREEZE FRAME DATA AND 1ST TRIP FREEZE FRAME DATA ". |
| Service $03 | DTCs | This mode gains access to emission-related power train trouble codes which were stored by ECM. |
| Service $04 | CLEAR DIAG INFO | This mode can clear all emission-related diagnostic information. This includes:
|
| Service $06 | (ON BOARD TESTS) | This mode accesses the results of on board diagnostic monitoring tests of specific components/systems that are not continuously monitored. |
| Service $07 | (ON BOARD TESTS) | This mode enables the off board test drive to obtain test results for emission-related powertrain components/systems that are continuously monitored during normal driving conditions. |
| Service $08 | - | This mode can close EVAP system in ignition switch ON position (Engine stopped). When this mode is performed, EVAP canister vent control valve can be closed. In the following conditions, this mode cannot function.
|
| Service $09 | (CALIBRATION ID) | This mode enables the off-board test device to request specific vehicle information such as Vehicle Identification Number (VIN) and Calibration IDs. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.