Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (ENGINE CONTROL SYSTEM - INTRODUCTION (VK45DE))ON BOARD DIAGNOSTIC (OBD) SYSTEMEMISSION-RELATED DIAGNOSTIC INFORMATIONSYSTEM READINESS TEST (SRT) CODESRT ITEM
2006 Infiniti FX35 AWD
SRT Item
2006 Infiniti FX35 AWDSECTION SRT Item
WARNING: This page is about a different car, the 2006 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
The table below shows required self-diagnostic items to set the SRT to "CMPLT".
SELF-DIAGNOSTIC ITEMS
| SRT item (CONSULT-II indication) | Performance Priority(1) | Required self-diagnostic items to set the SRT to "CMPLT" | Corresponding DTC No. | ||
|---|---|---|---|---|---|
| CATALYST | 2 | Three way catalyst function | P0420, P0430 | ||
| EVAP SYSTEM | 2 | EVAP control system purge flow monitoring | P0441 | ||
| 1 | EVAP control system | P0442 | |||
| 2 | EVAP control system | P0456 | |||
| HO2S | 2 | Air fuel ratio (A/F) sensor 1 | P0133, P0153 | ||
| Heated oxygen sensor 2 | P0137, P0157 | ||||
| Heated oxygen sensor 2 | P0138, P0158 | ||||
| Heated oxygen sensor 2 | P0139, P0159 | ||||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.