SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (ENGINE CONTROL SYSTEM - INTRODUCTION (VK45DE))BASIC SERVICE PROCEDUREIDLE AIR VOLUME LEARNINGOPERATION PROCEDUREWITH CONSULT-II
2006 Infiniti FX35 AWD

With CONSULT-II

2006 Infiniti FX35 AWDSECTION With CONSULT-II
WARNING: This page is about a different car, the 2006 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
  2. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
  3. Start engine and warm it up to normal operating temperature.
  4. Check that all items listed under the topic PREPARATION (previously mentioned) are in good order.
  5. Select "IDLE AIR VOL LEARN" in "WORK SUPPORT" mode.
    Fig 1: CONSULT-II Display - IDLE AIR VOL LEARN
    G04074549Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Touch "START" and wait 20 seconds.
    Fig 2: CONSULT-II Display - START
    G04074550Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Make sure that "CMPLT" is displayed on CONSULT-II screen. If "CMPLT" is not displayed, Idle Air Volume Learning will not be carried out successfully. In this case, find the cause of the incident by referring to the DIAGNOSTIC PROCEDURE below.
  8. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.
    ITEM SPECIFICATIONS

    ITEM SPECIFICATION
    Idle speed 650 +/- 50 RPM (in P or N position)
    Ignition timing 12 +/- 5° BTDC (in P or N position)
    Fig 3: CONSULT-II Display - WORK SUPPORT
    G04074551Courtesy of NISSAN MOTOR CO., U.S.A.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.