Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISELECTRICALGAUGESDRIVER INFORMATION SYSTEMREAR VIEW MONITORSYSTEM DESCRIPTIONPOWER SUPPLY AND GROUND
2006 Infiniti FX35 AWD
Power Supply And Ground
2006 Infiniti FX35 AWDSECTION Power Supply And Ground
Power is supplied at all time
- through 10A fuse [No. 19, located in fuse block (J/B)]
- to rear view camera control unit terminal 1.
When ignition switch is in ACC or ON position, power is supplied
- through 10A fuse [No. 6, located in fuse block (J/B)]
- to rear view camera control unit terminal 2.
When ignition switch is in ON or START position, power is supplied
- through 10A fuse (No. 83, located in IPDM E/R)
- to back-up lamp relay terminals 1 and 3.
Ground is supplied
- to rear view camera control unit terminal 3
- through grounds M35, M45 and M85.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.