Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Turn Signal Input Inspection
- CHECK TURN SIGNAL INPUT
Check turn signal input "TURN SIGNAL" in "DATA MONITOR" mode with CONSULT-II.
"TURN SIGNAL"
When lighting switch is in TURN RH position : RH
When lighting switch is in TURN LH position : LH
When hazard switch is turned ON : RH/LH
OK or NG
OK : INSPECTION END
NG : Check turn signal and hazard warning lamps system, and repair or replace corresponding parts. Refer to "HOW TO PROCEED WITH TROUBLE DIAGNOSIS ".
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.