Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISELECTRICALGAUGESDRIVER INFORMATION SYSTEMCOMPASSZONE VARIATION SETTING PROCEDURE
2006 Infiniti FX35 AWD
Zone Variation Setting Procedure
2006 Infiniti FX35 AWDSECTION Zone Variation Setting Procedure
NOTE:
The zone setting is factory preset ("default" setting) to zone 8.
- Press and hold the inside mirror switch for 6 - 9 seconds.
- The current zone setting appears on the compass display.
- Find the current geographical location number in the Zone Variation Chart.
- Select the new zone number. (Press the inside mirror switch until the new zone number appears on the compass display.)
- After select the new zone number, the compass display will automatically shows a direction within a few seconds.
- Preform the following Calibration Procedure for more accurate indications.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.