Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISELECTRICALGAUGESDRIVER INFORMATION SYSTEMCOMBINATION METERSSYSTEM DESCRIPTIONFAIL-SAFE
2006 Infiniti FX35 AWD
System Description: Fail-Safe
2006 Infiniti FX35 AWDSECTION Fail-Safe
Combination meter performs fail-safe operation when unified meter and A/C amp. communication is malfunctioning.
FUNCTION CHART
| Function | Fail-safe operation | |
|---|---|---|
| Speedometer | Return to zero. | |
| Tachometer | ||
| Fuel gauge | ||
| Water temperature gauge | ||
| Illumination control | Combination meter illumination | Change to nighttime mode. |
| ODO/trip meter | Integrate in response to 8-pulse input. | |
| A/T position indicator | The display turns OFF. | |
| Warning buzzer | The warning buzzer turns OFF. | |
| Warning lamp/indicator lamp | ABS warning lamp | The lamp turns ON. |
| VDC OFF indicator | ||
| SLIP indicator | ||
| Brake warning lamp | ||
| Low tire pressure warning lamp | ||
| AWD warning lamp | ||
| Door warning lamp | The lamp turns OFF. | |
| SET indicator lamp | ||
| CRUISE indicator lamp | ||
| ICC warning lamp | ||
| A/T CHECK warning lamp | ||
| Oil pressure warning lamp | ||
| Snow mode indicator lamp | ||
| Turn signal indicator | ||
| Malfunction indicator lamp | ||
| High beam indicator | ||
| Key warning lamp | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.